RE: RE: Passing parameter back to calling CL -- C400-L

Subject: RE: [C400-L] RE: Passing parameter back to calling CL
From: "David C. Shea" <dshea@xxxxxxxxxxxx>
Date: Sun, 24 Oct 2004 23:59:24 -0400
List-archive: <http://archive.midrange.com/c400-l>
List-help: <mailto:c400-l-request@midrange.com?subject=help>
List-id: C programming iSeries / AS400 <c400-l.midrange.com>
List-post: <mailto:c400-l@midrange.com>
List-subscribe: <http://lists.midrange.com/mailman/listinfo/c400-l>, <mailto:c400-l-request@midrange.com?subject=subscribe>
List-unsubscribe: <http://lists.midrange.com/mailman/listinfo/c400-l>, <mailto:c400-l-request@midrange.com?subject=unsubscribe>

I have been meaning to thank everyone on this list for helping me
through my struggles with passing the parameters back and forth to my
little C program.  I am happy to report that all is well - my C program
works, and my CL program is getting the answer it was looking for.

Thanks again.

********************************************************
Go... FASTER!  Without an Upgrade!
ARCTOOLS/400(tm) and ReorgWizard(tm)
http://www.arctools.com
DCSoftware, Inc.
Ph: (508) 435-8243
Fax: (508) 435-4498
********************************************************

As an Amazon Associate we earn from qualifying purchases.

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.