Re: Accessing Domino iSeries at two addresses for iNotes

["Patrick Trapp" <ptrapp@xxxxxxxxxxxx>]

We were able to ping it from both networks -- it responds fine for Notes 
clients.

It's more like the iSeries or the Domino server is configured to not allow 
HTTP from that network port.  Is that possible?

Patrick




Robert Laing <rlaing@xxxxxxxxx> 
Sent by: domino400-bounces+ptrapp=nex-tech.com@xxxxxxxxxxxx
11/06/2006 11:08 AM
Please respond to
Lotus Domino on the iSeries / AS400 <domino400@xxxxxxxxxxxx>


To
Lotus Domino on the iSeries / AS400 <domino400@xxxxxxxxxxxx>
cc

Subject
Re: Accessing Domino iSeries at two addresses for iNotes






Are you trying to access via the IP address or a DNS name ?  First thing 
to try is to ping either(both) the IP and DNS name to make sure the server 

is reachable from that network.

If it was a security issue, you should be prompted by an authentication 
screen.

Bob 






"Patrick Trapp" <ptrapp@xxxxxxxxxxxx> 
Sent by: domino400-bounces+rlaing=gemko.com@xxxxxxxxxxxx
11/06/2006 11:36 AM
Please respond to
Lotus Domino on the iSeries / AS400 <domino400@xxxxxxxxxxxx>


To
lnotes-l@xxxxxxxxxxxxxxxxxx, domino400@xxxxxxxxxxxx
cc

Subject
Accessing Domino iSeries at two addresses for iNotes






We have an iSeries hosting Domino for two distinct private networks that 
are using different IP schemes, thus it has a different IP address bound 
to each NIC port.  The Domino server responds fine to anyone using a Notes 


client on either network and responds find to anyone using iNotes from the 


original network.  However, anyone trying to access the server from the 
second network (just recently set up) fails with a "Web Page cannot be 
displayed" almost immediately.  The speed of the response makes me think 
that it is finding the server and being rejected for security reasons (as 
opposed to not finding the server at all or finding the server but timing 
out due to the server being busy).

Any suggestions for how to get the server to respond to either network?

I did notice that the IP address for the new port is not present on the 
hosts table, but it is using the same name for both IP addresses, so I am 
concerned about putting the same server name into the hosts file twice. Is 


this a problem?

Thanks in advance,
Patrick
_______________________________________________
This is the Lotus Domino on the iSeries / AS400 (Domino400) mailing list
To post a message email: Domino400@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/domino400
or email: Domino400-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/domino400.



_______________________________________________
This is the Lotus Domino on the iSeries / AS400 (Domino400) mailing list
To post a message email: Domino400@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/domino400
or email: Domino400-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/domino400.