Re: Cannot retain Network config with SLES 10 in LPAR

[Pete Helgren <Pete@xxxxxxxxxx>]

One clarification:

I went back in using *YaST* and I could see the IP address and subnet 
THERE... NOT with ifconfig as indicated below.

Pete Helgren wrote:
> All was well.  But when I bounced SLES I lost the settings I had added 
> so I went back and added them using ifconfig at the command line again 
> (the IP and subnet WERE there).
>
>
> Thanks,
>
> Pete
>
>
> _______________________________________________
> This is the Linux/400 Discussion (LINUX400) mailing list
> To post a message email: LINUX400@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/linux400
> or email: LINUX400-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/linux400.
>
>
>