RE: Version 7 Custom definitions

[LDegnon@xxxxxxxxx]

Thanks for the response Joe.

I had a look at the files, and both of the 'CST' files were empty, both in 
the version 6 environment and the version 7 environment.  The DFNAGR was 
populated in both.  The DFNDSC did not exist in the version 7 environment, 
so I copied it over and tried the Conversion again.  Still nothing...

I am SOOO close to 7...



Lloyd H. Degnon
I.S. Manager
AmPro Computers, Inc.
5215 Hellyer Ave.
Building #110
San Jose, CA 95138
(408) 360-4365
ldegnon@xxxxxxxxx 
www.AmPro.com 



"Joe Perrault" <JRPERRAULT@xxxxxxxxxxx> 
Sent by: mapics-l-bounces@xxxxxxxxxxxx
10/12/2005 11:50 AM
Please respond to
MAPICS ERP System Discussion <mapics-l@xxxxxxxxxxxx>


To
"MAPICS ERP System Discussion" <mapics-l@xxxxxxxxxxxx>
cc

Subject
RE: [MAPICS-L] Version 7 Custom definitions







We had the same problem and followed this procedure from the support
site:

Files for integrator and custom definitions conversion:
     CSTAGR
     CSTDSC         [CNV/ERR]
     DFNAGR
     DFNDSC         [CNV/ERR]
Migration brings these files over from R6 to R7, and conversion is run,
reference SH14413 section 7.
After conversion is run CSTDSC and DFNDSC will have [CNV/ERR] appended.
If the files are empty, after migration,  the workaround is to CPYF
*REPLACE from the files in  R6 and rerun the conversion in section 7 of
SH14413. 


Joe Perrault

-----Original Message-----
From: LDegnon@xxxxxxxxx [mailto:LDegnon@xxxxxxxxx] 
Sent: Wednesday, October 12, 2005 1:39 PM
To: MAPICS ERP System Discussion
Subject: [MAPICS-L] Version 7 Custom definitions

I have followed the instructions to the letter for Migrating Custom
definitions from ver. 6 browser to ver. 7 Powerlink.  Says that it has
completed, but get nothing.  Anyone else have this issue?  How did you
resolve it?

Thanks,



Lloyd H. Degnon
I.S. Manager
AmPro Computers, Inc.
5215 Hellyer Ave.
Building #110
San Jose, CA 95138
(408) 360-4365
ldegnon@xxxxxxxxx
www.AmPro.com
_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list To post
a message email: MAPICS-L@xxxxxxxxxxxx To subscribe, unsubscribe, or
change list options,
visit: http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives at
http://archive.midrange.com/mapics-l.


_______________________________________________
This is the MAPICS ERP System Discussion (MAPICS-L) mailing list
To post a message email: MAPICS-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/mapics-l
or email: MAPICS-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/mapics-l.