Re: CLIENT ACCESS Configuration

[Vern Hamberg <hambergv@xxxxxxxxxxxxxx>]

Faisal

At 08:04 AM 11/23/97 +0500, you wrote:
>Does any one know the complete procedure of configuring client access to
>the AS/400 over the token ring network. Whenever I try to configure the
>PC it says the communication link broken. IF I try to ping the AS/400
>there is no reply . Any suggestions

Be sure TCP/IP is set up and running on the 400, and on your PC. On the
400, be sure to STRHOSTSRV *ALL.

There's good help at <http://www.brooksnet.com>, as well as
http://www.as400.ibm.com/clientaccess>, where they have step-by-step guides
to installation.

HTH

Vernon Hamberg
Systems Software Programmer
Old Republic National Title Insurance Company
400 Second Avenue South
Minneapolis, MN 55401
(612) 371-1111 x480


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---