RE: CA/400 transfer PC to AS400: PC lockup and file still in ...

[David Dunfield <ddunfie@xxxxxxxxxxxx>]

Before you power down, check your subsystems for a disconnect job. It may 
be the failed job is in disconnect status. If you find the job end it.

-----Original Message-----
From:   SROACH [SMTP:SROACH@manus.com]
Sent:   Tuesday, June 16, 1998 2:37 PM
To:     MIDRANGE-L@midrange.com
Subject:        CA/400 transfer PC to AS400: PC lockup and file still in ...

Subject: CA/400 transfer PC to AS400: PC lockup and file still in use on 
AS400?

Hello all:

I have a problem:  One of our DE personnel tried to copy a file from her PC 
to
an AS400 folder (this had been done several times before).  Her PC 
locked-up as
a result, and now no one can access the file, not even Qsecofr.  The system 
is
still seeing the file as still in use.  Our lead programmer thinks the only 
way
to get it back is to power down the AS400.  Has anyone else had this 
problem?  I
would appreciate any suggestions.

Thank you

Steve Roach
Manus Direct
Seattle
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to 
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: 
david@midrange.com
+---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---