RE: Table saw shake

[Chris Bipes <ChrisB@xxxxxxxxxxxxxxx>]

What does this have to do with AS400's.  Do you have an interface to your
saw?

-----Original Message-----
From: Pat Barber [mailto:MBOCEANSIDE@postoffice.worldnet.att.net]
Sent: Monday, July 26, 1999 1:49 PM
To: MIDRANGE-L@midrange.com
Subject: Table saw shake


I forgot to mention, in all my excitement this morning, the table
saw vibration went away with a belt change and reinstalling motor
on saw(per installation instructions)... My old belt looked fine,
but apparently developed a "set" from lack of use in all of the recent
heat wave(which keeps me away from saw). I also did minor tune up of
fence and guard/splitter.. I also went out and purchased a new
Freud LU87 24 tooth thin kerf rip blade, which made a WORLD of
difference
in ripping that nasty old pressure treated 2x10's etc,etc.... I
thought all the hoopla about thin kerfs was just that , HOOPLA, but
no indeed, they do make a huge difference...

I also ordered a set of machined pullys and a link belt, which ought to
help out quite a bit <>>><>><><><>
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---