Re: 4234 Printer Question - DON'T laugh ;-)

[Chuck Lewis <clewis@xxxxxxxxxx>]

THANK YOU Cyndi !!!

We are running 4-part exclusively and had the A-E deal set OK but probably need
to play around with the "dot" deal !

Again, thank you !!

Chuck

Cyndi Bradberry wrote:

> The Pointer with the Dots is the Tension Control. The bigger the dot, the
> tighter the paper is held. The Lever with the A - E is the Forms Thickness
> Control. Both of our printers have always had the Tension set on the
> smallest dot, and we use about an 'A' for thickness. These printers handle
> check stock and plain paper at these settings.
>
> Thanks,
> Cyndi
>
> -----Original Message-----
> From: Chuck Lewis [mailto:clewis@iquest.net]
> Sent: Friday, September 17, 1999 5:31 AM
> To: MIDRANGE-L@midrange.com
> Subject: Re: 4234 Printer Question - DON'T laugh ;-)
>
> THANKS Cyndi !!
>
> When you open the printer up, there is a lever on the left hand side (Blue)
> with
> letters A through E. top to bottom. JUST to the back of that is a Knob that
> controls a "pointer" with a scale of "dots", smaller to bigger. Do you
> remember
> what this one does ? I've looked in THE manual we have (the setup manual is
> all
> we have and there is NOTHING in there...).
>
> TIA !!!
>
> Chuck
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---