Re: Configuring an Ethernet Card

["Mike Buglass" <list_receiver@xxxxxxxxxxxx>]

Arlene,

here is a quick guide to seting up an ethernet line for IP

1.    use the WRKHDWRSC *CMN command to get a list of communications
resources on the screen
2.    scroll through the list until you find "Ethernet port" in the
description and make a note of the associated resource (CMNxx)
3.    prompt the CRTLINETH command with F4
4.    enter a name for the line in the line description field
5.    enter the resource from step 2 in the resource name field
6.    set the line speed and duplex parameters as required - if in doubt
leave them as default
7.    prompt the ADDTCPIFC command with F4
8.    enter the line description from step 4
9.    enter the ip address and subnet mask as required
10.  type VRYCFG linedesc *LIN *ON
11.  type STRTCPIFC ipaddres



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---