Re: CPF3532

["nomad" <nomad@xxxxxxxxx>]

The msg text is just a bit misleading I think -- the serviced job is not
active at that point (still on a job queue) not "ended".

You proceed to enter your breakpoints after the job is released (F10 then
DSPMODSRC if you're using ILE which you should be -- it's tons easier!)

S.
----- Original Message -----
From: <Danny.Jahr@lawson.com>
To: <MIDRANGE-L@midrange.com>
Sent: Tuesday, December 28, 1999 10:41 PM
Subject: CPF3532


>
> I get the msg:
>
> Message . . . . :   Job being serviced ended.
> Cause . . . . . :   The serviced job has ended.
>
> When I STRDBG, but the job hasn't ended.
>
> I submit the job to a jobq that has no subsystem so
> that I don't have to hold the subsystem.  I STRSRVJOB,
> and then STRDBG and get the CPF3532 msg.  At that
> point I do a CHGJOB and move the job to QBATCH and
> then I get the correct msg:
>
> The serviced job has been released from the job queue.
> Press Enter to start the job or F10 to enter debug
> commands for that job.
>
> I didn't find any APARs on the msg,  so is it buggy or what?
>
>
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator:
david@midrange.com
> +---
>

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---