Cume C9313440

["T. Jessica Miller" <tealem@xxxxxxx>]

Hi,

I have a problem (that has also been reported by two of our customers) that
occurred upon the install of the latest cume for V4R4, C9313440.

When connected via any terminal session that uses a device (i.e., telnet
extended, DLC, NWSAA, Anynet, etc.), if you close the session using the X while
on a green screen rather than disconnecting properly you cannot reconnect to 
that
device.  At this point you get an error that states that the device is in use or
not active.  If you look at the device it is in an varyon pending or active 
state
and no one is connected to it. This happens with both our emulator and with
Client Access V3R2.

Removal of the cume fixes the problem.  Has anyone had this problem and if so,
have you been able to find any fixes for it?

Thanks,

Jessica

--
T. Jessica Miller
WRQ Technical Engineer
WRQ Inc, Makers of Reflection and Express Software


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---