Problem with command: WRKUSRJOBQ

[pike4@xxxxxxxxxxxxx]

When using this command, if you take a *YES for the 'Allow Changes' option, it 
allows you to type a '2' there, and then brings up a screen that is headed 
CHGJOB. However, it is a modified version of CHGJOB, with out the ability to 
change the job q, for example. Is there a switch somewhere that would give you 
the full CHGJOB parameters?

Thanks,

Phil Kestenbaum
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---