Re: locked myself out

[Quazy <quazy@xxxxxxxxxxxx>]

use tfrjob

At 05:11 PM 10/5/00 -0400, you wrote:
>I had a problem yesterday - locking myself out of the system, by 
>submitting a SAVSYS (opt21) - and not able to answer the message to the 
>QSYSOPR.
>As I could not do it by all defaults - (stopped at damaged object)
>         -       Prompt for commands - Y
>         -       Check for active files - Y
>         -       Message queue delivery -   *BREAK
>         -       Start Time              - *CURRENT
>I  was advised to go for unattended save -
>         -       I put the reply in the list :
>         ADDRPYLE SEQNBR(902) MSGID(CPA3708) RPY(?G?)
>           Changed the job :
>         CHGJOB INQMSGRPY(*SYSRPYL)
>
>Then changed the defaults to :
>
>         -       Prompt for commands - N
>         -       Check for active files - N
>         -       Message queue delivery -   *NOTIFY
>         -       Start Time              - *CURRENT
>
>And tried again (the damaged object was supposed to be marked as damaged 
>from the first try) and got a massage that it is waiting on massage on the 
>QSYSOPR. And could not respond to the massage - all subsystems were down.
>
>So I have more than one question :
>         -       how can I make the second session on the console 
> (0,1)  to go to QCTL, so if I am locked by a message - I could go there 
> and unlock myself.
>         -       Is it possible really the second pass to save all?(if 
> it?s been only one damaged object)
>         -       Did I do something really stupid !?
>         (the system is V3.7)
>         Thanks in advance for any advise/thoughts.
>
>         Valentin
>
>
>+---
>| This is the Midrange System Mailing List!
>| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
>| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
>| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator: david@midrange.com
>+---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---