At 10:16 AM 10/31/00 +1300, you wrote:
There are a number of bad options.
The best solution is to re-scratch the system with another option 24, and
then chose the option to add all the DASD. This way you will get
the best possible scatter.
If you are not concerned about DASD performance, go into SST and:
Option 3 - Work with disk units
Option 6 - Work with disk unit information (if memory serves me
correctlY0
and then fish around for an option to add.
Al
Hi List,
I have upgraded my Model 200 from V3R1 to V3R2 all OK .I chose option 24
when installing the LIC from tape to erase all the data on the load
source drive.because for some strange reason option 23 would not work--I
suspect probaly because the LIC on V3R1 is diffent to the LIC on
V3R2.
............but and made a big error.(I ignorned the option
during OS install to add all the drives to the ASP) Hence did not add all
the disk drives........................
3 x 6605 disks drives to the Storage Pool hence Im running on just
"one disk drive ",the load source drive!!!!
I can all see four disks with WRKDSKSTS but of course only
the load source drive is in the pool
I have no manuals and I was wondering if any one can tell me
the correct proceedure with commands to safely add the drives by
command.?
cheers
Dave Win2000 AS
DAVE
+--------------------------------------------------+
| Please do not send private mail to this address. |
| Private mail should go to
barsa@ibm.net. |
+--------------------------------------------------+
Al Barsa, Jr. - Account for Midrange-L
Barsa Consulting Group,
LLC.
400 > 390
Phone: 914-251-1234
Fax: 914-251-9406
http://www.taatool.com
midrange.com
