RE: CA Express and Life Certainties (A question appears at the end)

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

What type of firewall is your client using?  He may be allowing the SNA
traffic thru but blocking the TCP/IP.  Is your AS400 running TCP/IP over
SNA?  Is your client running TCP/IP over SNA?  Start looking there.  After
you answer those question, if you still cannot connect, post more detail
here and I will try to further assist.

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

-----Original Message-----
From: DAsmussen@aol.com [mailto:DAsmussen@aol.com]
Sent: Thursday, November 16, 2000 12:01 AM
To: midrange-l@midrange.com
Subject: CA Express and Life Certainties (A question appears at the end)

I have a client moving from Rumba to CA Express (4.5.1) as part of a 
corporate-wide standardization project.  Said client has several systems 
attached throughout the continent via TCP/IP locally, and at least one 
customer remotely.  This client has very few connections actually described 
on my local AS/400, in fact, none explicitly.

I'm no TCP/IP expert, but I do know this.  I can connect CA Express to my 
local host via the Wizard without difficulty using the system name.  I can 
further connect to one of our remote locations that appears on the local 
AS/400 under NETSTAT with a generic address of First Three Digits (dot) 
Second Three Digits (dot) zero (dot) zero where the succeeding zeros are 
actually more explicit numbers, using the explicit number under CAE and a 
setting of "Server".  I _CANNOT_ seem to connect to the remote customer 
utilizing the same methodology used for the remote in-house location, and
the 
remote customer has no similar generic entry under NETSTAT.

I also know that, after adding a HOSTS entry to my NT machine, I can PING
and 
TELNET to the remote customer under DOS.  I can also PING and TELNET to the 
remote customer via a session on our local hosting AS/400.  However, I 
_CANNOT_ seem to connect to the remote customer using _ANY_ settings under 
CAE.  Rumba (that we're replacing) on our old system is no problem.  The old

version of NetSoft on my laptop is no problem.  CAE _IS_ a problem.

Can anyone help me here?

Regards,

Dean Asmussen
Enterprise Systems Consulting, Inc.
Fuquay-Varina, NC  USA
E-mail:  DAsmussen@aol.com
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---