Re: RPG use of Stored Procedure result set

["Eric N. Wilson" <doulos1@xxxxxxxx>]

Hello AIV,

> The question is, if my Stored Procedure returns a result set, and I want
> to read it from an RPG client program, how am I supposed to
> define/use/read it in RPG ?
> Any one had any experience with this?

One way is to use the SQL CLI interface. This is how I have done it
and then I make a program to serve as a SPECIAL device so that mere
mortals can use this :-) Check out the Red Book so often quoted "Who
knew you could do that..." There is a good section on using the SQL
CLI and note, you do not have to have the SQL development kit to use
it.


----------------------------------
Eric N. Wilson
President
Doulos Software and Computer Services


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---