RE: Display station connection question/issue?

["Sims, Ken" <KSIMS@xxxxxxxxxxxxxxxx>]

Hi Mark -

>All ok

Some of the newer workstation controllers run at higher speeds and/or do
other things that may cause some devices not to work properly.  Check out
the following APAR:

http://as400service.rochester.ibm.com/n_dir/NAS4APAR.NSF/c79815e083182fec862
564c00079d117/7d80c34f0dac1a5f8625675a002c445a?OpenDocument

To summarize: if this is what is causing your problem, you can disable the
controller enhancements as follows:

CRTDTAARA DTAARA(QSYS/[controller name]) TYPE(*CHAR) VALUE('FFFFFF')

Vary the controller off and back on.

This will work on V4R3 and later as is.  For V4R1 and V4R2 you need some
PTFs (see the APAR).

Ken
Southern Wine and Spirits of Nevada, Inc.
Opinions expressed are my own and do not necessarily represent the views of
my employer or anyone in their right mind.

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---