Re: Decision Data ES/PCI Twinax card and Windows 98SE

["Neil Palmer" <neilp@xxxxxxxxxxx>]

All I see on the 400 is that it recognizes a card, auto-configs a device
(3196 in this case, based on the emulation mode selected) then the device
(session) crashes with:
Message ID . . . . . . :   CPI9350       Severity . . . . . . . :   70
Message type . . . . . :   Information
Message . . . . :   Error with device *N on work station controller CTL01.

Cause . . . . . :   Work station controller CTL01 detected an error in
either
  a command or data sent by device *N.

Error log showed:
                                         Serial
 Resource          Type      Model       Number                  Address

 DEVICE            3196       0A1        00-00000 0020-000102FF

 Error log ID  . . . . . . :   00023143     Sequence . . . . . . : 38260
 Date  . . . . . . . . . . :   05/02/02     Time . . . . . . . . :
14:24:56
 Reference code  . . . . . :   0191         Error code . . . . . :
00000000
 Table ID  . . . . . . . . :   26610001     IPL source . . . . . :   B
 Error type  . . . . . . . :   Permanent
 Description . . . . . . . :
 WS IOP detected busy time-out from device

...Neil






Pat Barber <mboceanside@worldnet.att.net>


        To:     midrange-l@midrange.com
        cc:
        Subject:        Re: Decision Data ES/PCI Twinax card and Windows 98SE


I have heard there are a number of problems with twinax cards and
the "higher speed" pc's. Some sort of clocking problem since the
ws controller expects one signal level and sees another, poooof !!!!

Your problems may be completely different, but I would look at the
job log very carefully for any funky hardware problems...

I would like to hear about twinax cards and higher speed machines
from the other folks....


Neil Palmer wrote:
>
> Anyone have any success with the above combination ?
> Have a customer (who installed this and actually got a signon display
for
> a few seconds, then the session crashed.
> They replaced the card, same problem.
> The PC is a Dell Optiplex GX150, PIII 1GHz, 256 SDRAM, running Windows
> 98SE.