Re: PPP Dial in setup question

[bdietz@xxxxxx]

>From V5R1  and using the internal modem you can do the following:

ADDTCPPTP CFGPRF(DIALINPPP)
          OPRMODE(*ANS)
          RSRCNAME(CMN01)
          MODEM('2771 Internal Modem')
          LCLINTNETA('10.1.1.1')
          RMTINTNETA('10.1.1.2')
          TEXT('Dial into the internal Modem')

I assume you meant 2771 internal modem
You will have to verify the comm port.
then from the WRKTCPPTP menu take optoin 9 to start the session.

Simple setup on the PC, just like connecting to your ISP
As setup above the IP address of the iSeries will be 10.1.1.1
and the IP address of you PC will be 10.1.1.2.




-------------------------
 Bryan Dietz
3X Corporation
614-410-9205






"jim essinger" <esinger@fmtc.com>
Sent by: midrange-l-admin@midrange.com
11/14/2002 12:24 PM
Please respond to
midrange-l@midrange.com


To
<midrange-l@midrange.com>
cc

Subject
PPP Dial in setup question






Greetings, and HELP!

I am new to setting up dial up PPP communications.  I have checked the
archives, and not found anything I can use, or I don't recognize it as
answering my question.

What I am trying to do is set up a PPP Line/Controller/Device description
in OS/400 to allow a PC to dial the iSeries, and get a 5250 screen.

What I would like to find is a setup wizard that will configure the
line/controller/device, and tell me how to set up the PC.  I am assuming
that the PC (W2k) would be using a dial up similar to dialing to an ISP
internet connection.  Then I would use Personal Communicaions (or iSeries
Access) 5250 to telnet into the iSeries, or give the 5250 a IP address and
act as if the iSeries was on the same LAN as the PC.

If you can point me to the archives, that would be good.  If you could
point me to a red book that would be great!  Any help is appreciated,
needed, and desired.

Thanks in advance!!


Jim Essinger
Senior Programmer/Analyst (!not! communications guru)
Student Loan Fund of Idaho
208-452-4058
800-548-9447
esinger@fmtc.com


_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
or email: MIDRANGE-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.