Re: A Green Screen Question

[Ken Sims <mr2087@xxxxxxxxx>]

Hi Bonnie -

> I need remove another workstation.  It has one cable in - none out.
> I assumed this was the end of the line.
>
> When I remove it, another workstation goes down - blinking light in upper
> right.
> Both are Info Window II's - configured as 3487s.
>
> Besides removing one of the twin-ax cables from the second workstation,
> is there an 'end of line' that needs to be done in workstation setup?
In addition to the things already mentioned, unterminated twinax can act as 
an antenna and feed electrical system noise on to the cable causing 
problems.  When removing the last workstation, be sure to disconnect the 
cable from the next-to-last workstation BEFORE disconnecting it from the 
last workstation.

Make sure, of course, that you disconnect the outgoing cable not the incoming.

If there is a termination switch on the next-to-last workstation, be sure 
to set it to terminate before disconnecting the cable.

Ken
http://www.ke9nr.net/
Opinions expressed are my own and do not necessarily represent the views of 
my employer or anyone in their right mind.