RE: IBM 6400 printer attached via ethernet

["DeLong, Eric" <EDeLong@xxxxxxxxxxxxxxx>]

Sounds like you have an older JetDirect box.....  Any chance you could use a
new unit?

Eric DeLong
Sally Beauty Company
MIS-Project Manager (BSG)
940-898-7863 or ext. 1863



-----Original Message-----
From: Karl Keller [mailto:kkeller@xxxxxxxxxxx]
Sent: Thursday, March 20, 2003 9:43 AM
To: midrange-l@xxxxxxxxxxxx
Subject: Re: IBM 6400 printer attached via ethernet


Vern,
Thanks for your response. I was aware of the the site that you provided the
link to and had created the following
device description for a 6400-015-A00 connected to the network with an
external HP JetDirect 300X :

CRTDEVPRT DEVD(PRT99) DEVCLS(*LAN) TYPE(3812) MODEL(1) +
         LANATTACH(*IP) PORT(9100) ATTACH(*DIRECT) ONLINE(*YES) +
         FONT(011 *NONE) FORMFEED(*CONT) SEPDRAWER(*FILE) +
         PRTERRMSG(*INFO) MSGQ(*CTLD) ACTTMR(170) INACTTMR(*SEC15) +
         LINESPEED(19200) WORDLEN(8) PARITY(*NONE) STOPBITS(1) +
         TRANSFORM(*YES) MFRTYPMDL(*IBM6400) PPRSRC1(*CONT132) +
         PPRSRC2(*NONE) ENVELOPE(*NONE) ASCII899(*NO) +
         IMGCFG(*NONE) CHRID(*SYSVAL) RMTLOCNAME('XX.XXX.X.XX') +
         SYSDRVPGM(*IBMSNMPDRV) +
         PUBLISHINF(*UNKNOWN *UNKNOWN *UNKNOWN *UNKNOWN *BLANK)

I'm able to vary on the printer, and start the printer. In the QSYSOPR
message que, I get a CPF3382 indicating that the writer started.
After about 10 seconds the writer goes back to varied on and I get a CPF3397
in QSYSOPR stating that the writer did not end normally.

When I check the joblog it says:

Message . . . . :   Could not establish SNMP communications with device
PRT99.
Cause . . . . . :   Was not able to establish SNMP communications with
device
  PRT99. The reason code is  2.  The reason codes and their meanings are as
  follows: 2 -  The device appears to be an SNMP device but does not support
  the required level of an industry standard SNMP protocol.

Any ideas?

TIA

Karl Keller
Information Systems
Girling Health Care, Inc.
(512) 458-3090 ext. 5040

Confidentiality Notice:  This e-mail message, including any attachments, is
for the sole use of the intended recipient(s) and may contain confidential
and privileged information.  Any unauthorized review, use, disclosure or
distribution is prohibited.  If you are not the intended recipient, please
contact the sender by reply e-mail and destroy all copies of the original
message.
_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.