Re: Save-while-active questions / concerns

[rob@xxxxxxxxx]

I think that step 1 will never execute.  I prompted ENDSBS, went to the 
top and hit F1, scrolled down to the list of monitorable messages and...
CPF1052     ENDSBS *ALL not allowed in current environment.
Cause . . . . . :   ENDSBS *ALL is allowed only from an interactive job 
that
  is started from a *SIGNON workstation entry in the controlling 
subsystem. 
  ENDSBS *ALL is not allowed from a target pass-through job.  

Rob Berendt
-- 
"All creatures will make merry... under pain of death."
-Ming the Merciless (Flash Gordon)




"David A Parnin" <daparnin@xxxxxxxxxxxxxxxxxx> 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
12/17/2003 09:23 AM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
midrange-l@xxxxxxxxxxxx
cc

Fax to

Subject
Re: Save-while-active questions / concerns







Thanks to everybody who replied.  I think I've got a better handle on the
concepts that I was missing.  Al makes a good case for the TAA Tool
SAVxxxACT commands which handles a lot of the details.  I may still
implement it with SAVLIB but we'll see.

The steps (as I understand them) are:
1.  Submit a job to QCTL to do a ENDSBS *ALL *IMMED.
2.  When a restricted state has been achieved start another subsystem.
3.  Starting that subsystem will also start the QSYSWRK subsystem so do a
ENDSBS QSYSWRK *IMMED
4.  Submit a job to the newly activated subsystem to monitor a message
queue for the message that the checkpoint has been established.
5.  Issue the SAVLIB command from the QCTL job with SAVACT(*SYNCLIB) 
PRECHK
(*YES) SAVACTWAIT(0) and a SAVACTMSGQ specified.
6.  When the job in the new job queue gets the checkpoint message then run
the job specified by the QSTRUPPGM to make the system available for use.

Feel free to correct me if I missed something or got something wrong.
Thanks again everybody.


Dave Parnin
Nishikawa Standard Company
Topeka, IN  46571
daparnin@xxxxxxxxxxxxxxxxxx


_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing 
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.