Re: VRYCFG at IPL problems

[Bryan Dietz <BDietz@xxxxxxxxxx>]

any chance the system is LPAR'd??
If so I have seen where the system will not vary lines/controllers/devices
if there are resources the used to be assigned to the primary that are not
"there" anymore.
I mean they show up as unknown devices in the hardware device manager in
SST.


----------------------------
Bryan Dietz
Aktion Associates

midrange-l-bounces@xxxxxxxxxxxx wrote on 04/20/2004 04:11:09 AM:

> Hello,
>
> we have two twinax controllers (CTL01 and CTL02) on our 810 with V5R2.
>
> During IPL, I will get a message like "Vary on at IPL for CTL01
finished".
> The same message for CTL02 will come up to 24 hours later?
>
> Up to yesterday, this didn't give a problem. But yesterday morning, I
> found that all twx devices on CTL02 were varied off!
> When I varied them on manually, I finally got the above message.
>
> Both controllers are configured to vary on at IPL.
>
> My guess is this is happening since our V5R2 upgrade in December 2003.
>
> Any ideas what is going on here?
>
> Regards,
>
> Oliver
>