RE: Virtual Ethernet

["don yattaw" <neal_dy@xxxxxxxxxxx>]

   I have attempted to use AnyNet, but when I do so, it uses the "nonvirtual"
   route to get to the other Lpar.  Both Lpar's have ethernet cards with
   configured tcp interfaces.  The AnyNet solution means that I can't
   specifiy a linelist for the controller and can't predetermine the route it
   will take myself.  I haven't actually attempted this for a while, but if
   memory serves me (and at times it still does), this was the problem.

    

   Don

    

   >From: "Doug Hart" <doughart@xxxxxxxxxxxx>
   >Reply-To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
   >To: "Midrange Systems Technical Discussion" <midrange-l@xxxxxxxxxxxx>
   >Subject: RE: Virtual Ethernet
   >Date: Sat, 8 May 2004 16:28:13 -0400
   >
   >Set up AnyNet.  SNA will then be able to talk over the TCP link.
   >
   >---
   >Doug Hart
   >
   >
   >
   >midrange-l-bounces@xxxxxxxxxxxx wrote:
   > >    I have virtual ethernet connecting two lpars.  I have configured
   > >    ip to work over the connection and as far as that goes everything
   > >    is working fine.  I would like to get sna over ip to work also,
   > >    but can't seem to get the controllers talking.  Does anyone have
   > >    any experience with this?  Is there any reason it shouldn't work?
   > >
   > >    When I configure the appc controller and attempt to vary it on, i
   > >    get a message cap5714 stating:
   > >    -- Controller xxxxxx runs over a protocol other than TCP/IP, and
   > >      each of the line descriptions found in the switched line list
   > >      (SWTLINLST) specifies a hardware resource (RSRCNAME parmeter)
   > > that only supports
   > >
   > >    TCP/IP.
   > >
   > >
   > >
   > >    Thanks,
   > >
   > >
   > >
   > >    Don Y
   > >
   > >
   > > ----------------------------------------------------------------------
   > >
   > >    Mother*s Day is May 9. Make it special with great ideas from the
   > >    Mother*s Day Guide!
   > > _______________________________________________
   > > This is the Midrange Systems Technical Discussion (MIDRANGE-L)
   > > mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx
   > > To subscribe, unsubscribe, or change list options,
   > > visit: http://lists.midrange.com/mailman/listinfo/midrange-l
   > > or email: MIDRANGE-L-request@xxxxxxxxxxxx
   > > Before posting, please take a moment to review the archives
   > > at http://archive.midrange.com/midrange-l.
   >
   >
   >_______________________________________________
   >This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
   list
   >To post a message email: MIDRANGE-L@xxxxxxxxxxxx
   >To subscribe, unsubscribe, or change list options,
   >visit: http://lists.midrange.com/mailman/listinfo/midrange-l
   >or email: MIDRANGE-L-request@xxxxxxxxxxxx
   >Before posting, please take a moment to review the archives
   >at http://archive.midrange.com/midrange-l.
   >

     ----------------------------------------------------------------------

   Check out the coupons and bargains on MSN Offers!