Re: RUNRMTCMD

[Thomas Hauber <thauber@xxxxxxxxxxxx>]

I did have that option set on the service.  And the user/password
combination was correct as well.


Thomas Hauber
Senior Programmer/Analyst
General Ribbon Corp.



CWilt@xxxxxxxxxxxx wrote:
> Thomas,
> 
> By default, that's not going to work.
> 
> In the service setup in control-panel or the admin tools, for the Incoming
> Remote Command service, you'd need to mark the box that says "Allow service
> to interact with the desktop"
> 
> This is one of the gotcha's I mentioned.
> 
> Also, the user name and password sent via RUNRMTCMD must match the user
> signed onto the PC.
> 
> 
> Charles
> 
> 
>>-------- Original Message --------
>>Subject: Re: RUNRMTCMD
>>From: "Thomas Hauber" <thauber@xxxxxxxxxxxx>
>>Date: Wed, September 08, 2004 1:58 pm
>>To: "Midrange Systems Technical Discussion" 
>><midrange-l@xxxxxxxxxxxx>
>>
>>I have been trying the following command simply as a test.  
>>From a PC 
>>command line this works, it does not work however from the 
>>iSeries using 
>>RUNRMTCMD.
>>
>>c:\winnt\system32\calc.exe
>>
>>The command from the iSeries is:
>>
>>RUNRMTCMD CMD('c:\winnt\system32\calc.exe') 
>>RMTLOCNAME('192.168.100.135' 
>>*IP) RMTUSER('thauber') RMTPWD() WAITTIME(10)
>>
>>The correct password is being entered in RMTPWD parameter 
>>in quotes to 
>>avoid any problems with case.
>>
> 
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>