RE: 5494 Remote Controller in a TCPIP network

["Carl Galgano" <cgalgano2@xxxxxxxxxxxxxxxxx>]

They use a MAC address:
The MAC address for the AS400 is in the line description and must be
referenced in the 5494 setup.
The MAC address is in the 5494 set up, and can be found in the APPC
controller description on the A400.
cjg

Carl J. Galgano
EDI Consulting Services, Inc.
600 Kennesaw Avenue, Suite 400
Marietta, GA  30060
(770) 422-2995 - voice
(770) 425-8391 - fax
mailto:cgalgano@xxxxxxxxxxxxxxxxx
http://www.ediconsulting.com
AS400 EDI, Networking, E-Commerce and Communications Consulting and
Implementation 
http://www.icecreamovernight.com
Premium Ice Cream Brands shipped Overnight

-----Original Message-----
From: Greg Wenzloff [mailto:GWenzloff@xxxxxxxxxxx] 
Sent: Friday, December 03, 2004 9:28 AM
To: midrange-l@xxxxxxxxxxxx
Subject: 5494 Remote Controller in a TCPIP network


We changed from leased lines to a frame relay network about 4 years ago.  At
that time I was not involved in setting this up.   There are 2 remote
workstation controllers at the distant side of the network.

I am being asked what is the TCPIP address of these 2 controllers.   I can
not find this info when I look at the controller's description or anywhere
else.

I'm not even sure that they have IP addresses.  Perhaps they work with MAC
addresses.

Could someone point me in the right direction on this.

TIA,
Greg Wenzloff
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe,
or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.