Program/Procedure Cross-Reference.

["Mike Pantzopoulos - (H/O)" <mpantzopoulos@xxxxxxxxxxxxxxxx>]

Is there anyway of finding what procedures are used by a program other
than scanning source or using an API? In other words any commands?
 
I tried DSPPGM and it shows me the modules, but not the actual
procedures referenced from the modules. I would have thought that this
would be fundamental information when allowing multiple procedures to be
defined in a single module? 

Thanks.  

Mike Pantzopoulos

EIG-Ansvar Limited


*********************************************************************************************************
This email and any files transmitted with it are confidential and intended 
solely for the use of the individual or entity to whom they are addressed. If 
you are not the intended recipient, any use, disclosure or copying of this 
message is unauthorised. If you have received this message in error, please 
reply using the sender's email address. 

This footnote confirms that this email message has been scanned for computer 
viruses. EIG-Ansvar Limited does not accept liability for any loss or damage, 
whether caused by our own negligence or not, that results from a computer virus 
or defect in the transmission of this email or any attached file. 

EIG-Ansvar Limited - Australia (A.B.N. 21 007 216 506)
Email : insure@xxxxxxxxxxxxxxxx

Eig-Ansvar Limited - New Zealand
Email : insure@xxxxxxxxxxxxxxxx

*********************************************************************************************************