RE: Problem with connection between LPARS

["Chris Bipes" <chris.bipes@xxxxxxxxxxxxxxx>]

I have run into this before, SNA one way only.  Go to the target system
and look at the authority of the communication objects. You may see
authorization errors in the job logs on the target system as well.
DSPLOG helps to find them if you are not generating job logs.


Christopher Bipes
Information Services Director
CrossCheck, Inc.

707.586.0551, ext. 1102
707.585.5700 FAX

Chris.Bipes@xxxxxxxxxxxxxxx
www.Cross-Check.com

Notice of Confidentiality: This e-mail, and any attachments thereto, is
intended only for use by the addressee(s) named herein and may contain
legally privileged and/or confidential information.  If you are not the
intended recipient of this e-mail, you are hereby notified that any
dissemination, distribution or copying of this e-mail, and any
attachments thereto, is strictly prohibited.  If you have received this
e-mail in error, please immediately notify me by e-mail (by replying to
this message) or telephone (noted above) and permanently delete the
original and any copy of any e-mail and any printout thereof.  Thank you
for your cooperation with respect to this matter.


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Pete Helgren
Sent: Friday, January 27, 2006 7:40 AM
To: Midrange Mailing List
Subject: Problem with connection between LPARS

I have been trying to sort this one out.  A customer had to rebuild an 
LPAR (saved the production partition "JCPS400A" and restored it as 
development "JCPSDEV").  That meant going through and changing some 
system settings so that we could get the communications between the 
LPAR's going again.

Telnet works between systems (both ways).  I can use STRPASTHR from the 
production side to the Dev side and I can use SAVRSTLIB from production 
to dev.  The problem is that I can't use STRPASTHR from the dev side to 
the production side or SAVRSTLIB from dev to production.

I looked at the APPC controller definitions and the communications 
entries and I am not seeing the problem.

Job log shows the following on SAVRSTLIB:
Ownership of object TXIDQ in QTEMP type *USRQ changed.
Ownership of object RESPQ in QTEMP type *USRQ changed.
APPC failure. Failure code is X'0009000000000000'.   
An error occurred during the SAVRSTLIB operation.    
An error occurred during the SAVRSTLIB operation.    

Job log shows the following on STRPASTHR:
 APPC failure. Failure code is X'68268004000032FE'
 APPC failure. Failure code is X'68268004000032FE'

QSYSOPR shows:

BIND sense code X'80040000' received for mode QSOCCT device JCPS400A
Session maximum not established for mode QSOCCT device JCPS400A.   
All sessions ended for device JCPS400A.                            
APPN session timed out following device selection.                 

I looked up both APPC error codes and didn't get much helpful 
information.  I am missing something simple, I am sure.  Any guesses 
what the likely cuprit is?