Reset SPCN Sequence

["Haase, Justin C." <justin.haase@xxxxxxxxxxxx>]

Folks,

Got an old 720 here of which I replaced a backplane in the 5065 because
the fiber transmitter went flaky.  Anyway - now that it's on the system,
the SPCN sequence reported on the operator panel of the 5065 is *09 when
it should be *02.  I am pretty sure that a function 33 from the control
panel should resequence SPCN, but I can't figure out how to get it to
that high of a number.

Anyone have the easy way to do this?  I'm pretty confident I need to be
in a manual-mode IPL to the DST menu, and then I should be able to do it
- I haven't done this in ages, do I then need to do the 25/26 to enable
extended functions - arrrgh!  Help!  Thanks.

Justin C. Haase - iSeries System Engineer
IBM Certified Systems Expert - System i
Kingland Systems Corporation


CONFIDENTIALITY NOTICE:  This e-mail communication, including attachments, is 
covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is 
confidential, and may be legally privileged.  If you are not the intended 
recipient or believe you received this communication in error, please reply to 
the sender indicating that fact and delete the copy you received.  In addition, 
retention, dissemination, distribution, copying, or otherwise use of the 
information contained in this communication is strictly prohibited.  Thank you.