RE: Runaway QHST

["Haase, Justin C." <justin.haase@xxxxxxxxxxxx>]

DR1 is lots different than ha lite and ha 1, AFAIK.  Not sure if the SPC
levels are equivalent.


--
Justin C. Haase - Solution Engineer
IBM Certified Systems Expert - System i
Kingland Systems Corporation

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of rob@xxxxxxxxx
Sent: Wednesday, December 13, 2006 8:41 AM
To: Midrange Systems Technical Discussion
Subject: Re: Runaway QHST

Curious, what level of Mimix were you on?

Installed    Installed 
 release     SPC 
 V4R4M0      SP076.00.0

Rob Berendt
--
Group Dekko Services, LLC
Dept 01.073
PO Box 2000
Dock 108
6928N 400E
Kendallville, IN 46755
http://www.dekko.com





pnelson@xxxxxxxxxx 
Sent by: midrange-l-bounces@xxxxxxxxxxxx
12/12/2006 10:23 AM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>


To
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
cc

Subject
Re: Runaway QHST






It turns out that the upgrade to 5.4 requires an upgrade to the MIMIX
DR1 
software. Despite what I was told 6 weeks ago that there would be no 
problems, when I finally got through to somebody who really knew the 
answer, I learned that the existing version of the MIMIX software
doesn't 
work right with 5.4. Lakeview's tech support folks knew about it and had

sent out emails about it. Unfortunately, nobody at Lakeview had placed
me 
or the client on the alert list.

The spike in the Mimix job logging was caused by the fact that instead
of 
replicating 50 to 100 objects each cycle, Mimix was grabbing all 9,000 
plus objects in the libraries eligible for replication.

I'll install the fix tomorrow.