|
It looks like the DTW_FORMAT command has a parameter with an invalid number value. the HELP Documentation says that one of these conditions exists: a) An input parameter contained a value which was not a valid format for a number. b) An input parameter contained a value which specified an exponent outside the supported range of -999,999,999 to +999,999,999. Try to revise the value of the parms and make sure none of the conditions above are present. Good luck! Peter Vidal PALL Corporation / SR Programmer Analyst, IT Development Group 10540 Ridge Rd., Ste 203, New Port Richey, FL 34654-5111 http://www.pall.com "Raise your sail one foot and you get ten feet of wind." Chinese Proverb
This mailing list archive is Copyright 1997-2026 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
