RE: rack config - items not showing

["Haase, Justin C." <justin.haase@xxxxxxxxxxxx>]

That's impressive.  :)  If you've got maintenance, might be worth a
phone call.

Justin C. Haase - Solution Engineer
IBM Certified Systems Expert - System i
Kingland Systems Corporation


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jerry Draper
Sent: Friday, February 02, 2007 3:23 PM
To: Midrange Systems Technical Discussion
Subject: Re: rack config - items not showing

The issue is that the drives show up in wrksyssts but not in the rack 
config printout.

Jerry

Haase, Justin C. wrote:
> AFAIK, a 7104 on a 270 is considered part of frame 1.  The cages are
not
> shown, either.  Nor are they shown on any system.
>
> As long as your disk drives and controller cards are showing up,
you're
> ok.
>
> Justin C. Haase - Solution Engineer
> IBM Certified Systems Expert - System i
> Kingland Systems Corporation
>
>
> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jerry Draper
> Sent: Friday, February 02, 2007 2:37 PM
> To: Midrange Systems Technical Discussion
> Subject: rack config - items not showing
>
> I have a small 9406-270 P05 with 18 35GB drives.  I go into SST, start
a
>   service tool, hardware service manager and press F6 to print a rack 
> config.
>
> Lo and behold it does not report the 7104 expansion unit nor the 7143 
> cage housing 12 drives.
>
> I thought the rack config was next to god in accuracy.
>
> What's up?
>
> Jerry