Need some assistance setting up operations console on 9406-600

["Julian Wolfe (FireflyST)" <fireflyst@xxxxxxxxxxxxx>]

Hi all,
 
I'm the proud owner of a 9406-600 that is currently set up to use Twinax as 
its console session.  I would like to change that to Operations Console.  I have
followed all the directions in the V5R1 manuals and set up the software properly
on the PC, it just cannot see the AS/400.  I have set the QAUTOCFG value during 
IPL, and it still defaults to twinax no matter what comms port I use.  Now, I 
have
2 cards in the system with WAN ports on them, but I'm not sure which one I 
should
be using for the operations console session.  The diagrams in the Operations 
Console
setup manual show a model 600 with only the dual WAN port card, which I have, 
but
above it in the second slot (I think) from the top, there is the twinax/WAN 
card,
which is used as the console at the moment.  if necessary I can pull the twinax 
card.
 
What should I do to get this working?  Nothing I change on the /400 side seems 
to
help.
 
Thanks
 
Julian