Re: How do I tell if STRASPBAL is still running?

[Bryan Dietz <bdietz400@xxxxxxxxx>]

Rob,  Maybe this doc will help:

http://www-912.ibm.com/s_dir/slkbase.NSF/1444e529a72ba96486256a6400681992/80a0c71876d5a872862567ca00770cb0?OpenDocument

I found it after doing a quick search for the task SMEQ000100.  I saw 
this running after I started the ASP ballance and looked at WRKSYSACT.

so give the following command a try  CHKASPBAL

check your joblog.

Bryan


rob@xxxxxxxxx said the following on 2/19/2007 2:25 PM:
> How do I tell if STRASPBAL is still running?  I am aware that STRASPBAL 
> and TRCASPBAL completion messages are sent to QHST.  So the following 
> command is handy if you want to see only information pertaining to these 
> commands.
> DSPLOG MSGID(CPI1474 CPI1475 CPI1476 CPI1477 CPI1478). 
>
> Message ID  Severity  Message Text 
>  CPI1474       10     ASP balancing successfully started for ASP &1. 
>  CPI1475       10     ASP balancing for ASP &1 ended. 
>  CPI1476       10     ASP tracing successfully started for ASP &1. 
>  CPI1477       10     ASP tracing for ASP &1 ended. 
>  CPI1478       10     ASP tracing data successfully cleared for ASP &1.
>
> > From GDIHQ:
> ASP balancing successfully started for ASP 1.   02/09/07        13:34:55 
> *CAPACITY
> ASP balancing for ASP 1 ended.                          02/09/07 15:44:06 
> *CAPACITY
> ASP tracing successfully started for ASP 1.     02/14/07        11:46:51
> ASP tracing for ASP 1 ended.                            02/16/07 08:10:17
>
> The first one was started by the addition of a new disk drive with the 
> option to add unit to asp and balance data.
>
> But if I just want to see if the asp balancing is still running how do I 
> tell?
> We plan on running the
> STRASPBAL TYPE(*USAGE)
> tonight, based off of our results from the TRCASPBAL.
>
> ps:  We have eighty three 4327 (70GB) disk arms in this lpar.  Ranging 
> from 0 to 12% busy and 88.8 to 89.4% used.
>
> Rob Berendt