|
I doubt you can really control where data goes on a "specific" drive since the system does a scatter load. The source load is only "specific" load you can really do to my knowledge. The CE function using DST of "gig-mig" or "pumping" a drive will move data to a specific drive but that can get awfully tricky since it's a disaster recovery method. I believe a unload/load is still the best method. Chris Bipes wrote:
I have just added 4 new drives to my system and built the raid-5 set. Before adding to the ASP I would like to migrate my load source to one of these new, larger drives. This would be in preparation for replacing the smaller drives with larger faster drives. Is this a DST function cause I could not see how in SST.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
