Re: Power requirements for an 810

[Pete Helgren <Pete@xxxxxxxxxx>]

The link you gave has that info:

Rated voltage and frequency5     100-127/200-240 V ac at 50-60 plus or 
minus 0.5 Hz

Footnote says this:

The power supplies automatically accept any voltage with the published 
rated voltage range. If dual power supplies are installed and operating, 
the power supplies draw approximately equal current from the utility 
(mains) and provide approximately equal current to the load.



Smith, Mike wrote:
> The main thing I'm looking for is the electrical requirements.  110
> -220?, special power cords, anything like that.
>
> We already have a UPS, although I fairly certain we would add the 810 to
> the UPS. 
>
> Michael Smith
> iSeries.mySeries.
>
>
> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Pat Barber
> Sent: Wednesday, December 05, 2007 10:50 AM
> To: Midrange Systems Technical Discussion
> Subject: Re: Power requirements for an 810
>
>
> What are you trying to figure out Mike ?
>
> The system requirements are very light for electrical.
>
> Are you configuring a UPS perhaps ?
>
> Smith, Mike wrote:
>
>   
> > Can someone tell me what the power requirements are for an  810.
> > I have been searching this morning, and have found this link
> > http://publib.boulder.ibm.com/infocenter/systems/scope/hw/index.jsp?top
> >     
> i
>   
> > c=/iphad/i52l.htm
> >
> > But I'm not sure how to interpet what it means though
> >
> > Thanks
> >
> > Michael Smith
> >
> >
> >  
> >
> >