RE: Can't get system to recognize new disk

["Evan Harris" <spanner@xxxxxxxxxx>]

Slight correction -> If you did the latter you will be provided with
*Fewer*options.

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Evan Harris
Sent: Friday, 7 December 2007 10:01 a.m.
To: 'Midrange Systems Technical Discussion'
Subject: RE: Can't get system to recognize new disk

Hi Joe

You don't say whether you did a manual IPL and accessed the Service tools on
the initial menu (the one that allows you to IPL your system) or just
started the system up and went into SST once the machine was running.

If you did the latter you will be provided with options.

The former is the DST (Dedicated Service Tools) function and as far as I am
aware is the only place you get the option to remove a disk.

Regards
Evan Harris


-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Joe Pluta
Sent: Friday, 7 December 2007 4:45 a.m.
To: 'Midrange Systems Technical Discussion'
Subject: RE: Can't get system to recognize new disk

> From: Jones, John (US)
>
> You have to remove the drive within SST and then add the replacement.
> Then it will let you rebuild.
>
> Since you've already done the physical swap consider this the logical
> swap.  And don't be concerned about it showing the serial number of the
> old drive when you go to rebuild the RAID set; it'll update to the
> replacement drive's s/n at some point.

I couldn't find the remove option, but I did find an option to rebuild the
failed drive, and so I took that.  It seems to be rebuilding it now.

Joe