RE: Using iSeries As Router -- MIDRANGE-L

I don't disagree with you.

But with Nat turned ON, I was not able to get to the iSeries.

Granted, it's probably because of some other combination of things I have
set up that required me to turn NAT off to make it work...but there you go.

I hate working with the networking side of things. I do it so infrequently
that I never remember from one year to the next what I did on some previous
setup to make it all play nice together.

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Scott Klement
Sent: Monday, June 02, 2008 12:23 PM
To: Midrange Systems Technical Discussion
Subject: Re: Using iSeries As Router

Perhaps this is a silly question, but... why do you have NAT turned
off? Seems to me that NAT is pretty much required in your scenario,
unless you have only one computer behind the router (but that doesn't
sound like the case...)

Shannon ODonnell wrote:

Hi,

Maybe a dumb question.but when it comes to networking, I am pretty

ignorant.

I recently got a new Wireless-N router (Linksys) to replace an older

Belkin

Wireless-G router.

My old network looked like this:

- ISP Modem

To - Belkin Router

iSeries to Belkin Router

PC's to Belkin Router

By turning NAT off on the Belkin (wouldn't work with NAT enabled), I was
able to get to my iSeries using both an internal IP address and an

external

IP address (from the outside world).

To achieve that, I defined a *DFTROUTE on my iSeries that pointed to the
Belkin router and then I created two interfaces, one with an external IP
address (that was a child of the ISP Modem's static IP address) and the
other interface was an internal IP address.

Worked great.

With my new Wirless-N router, I tried that same setup (only pointing the
*DFTROUTE to the new router IP address) and now I cannot get to the

iSeries

through an outside IP address. I can still get to it internally (with a

new

internal IP address interface), but not through the external IP address.
Turning NAT off on this router makes no difference in this setup.

I cannot figure out the right combination of settings on the new modem

that

will allow me to point an external IP address to the iSeries such that I

can

access it outside the network.

I also tried doing port forwarding and setting up the iSeries outside the
DMZ. Didn't work.

So. my question is. I have two Ethernet cards in my iSeries. I'm

wondering

if I could set my network up so that the ISP Modem goes directly into my
iSeries (which would put it completely outside of the local router) and
then, using the other Ethernet card, pass all local PC traffic in and out
through the Wireless-N router and then through the iSeries and out to the
internet that way.

Is it possible to use the iSeries in this manner? In effect, I'd be

turning

it into a router (sort of).

I don't even know what I'd have to configure on the iSeries to achieve

this

or if it's even possible.

Anyone ever tried this?

Shannon O'Donnell