Are you sure this is a problem, that the 520 receives a Utility Failure?
When you switch the UPS to BYPASS, you just cut power to the UPS, so it
probably signals a Utility Failure.
Steve
Steven Morrison
Fidelity Express
Bob Schwartz <rschwartz@xxxxxxxxxxxxxxx>
Sent by: midrange-l-bounces@xxxxxxxxxxxx
10/29/2008 02:27 PM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
To
"midrange-l@xxxxxxxxxxxx" <midrange-l@xxxxxxxxxxxx>
cc
Subject
9406-520 Eaton Powerware 9330 Cable
Has anyone had any success hooking up a 9406-520 to an Eaton PowerWare
with the xSlot Relay Interface card?
We have built a cable with the pinots as described in the Eaton/IBM docs.
When we put the UPS on Bypass the 520 sees it as a Utility Failure.
Here is Eaton's page for the xSlot documentation:
http://www.powerware.com/UPS/Connectivity/Relay_Interface_info.asp
IBM document number 350941184 for the IBM side of the pin outs.
I am using a DB15 to DB9 cable from Eaton w/o the IBM convertor cable, and
have the ability to remove/insert the pins on each end of the cable as
needed.
Cable DB15 to DB9 Relay Card Cable For PowerWare UPS And AS 400 Model
9406, 25ft
Eaton/PowerWare Corp.
Item #: 5837651
Mfr. Part #: 103004349-5501
Any help is greatly appreciated.
Thank you,
Bob Schwartz
Director of Technology Services
Glynn County School System
midrange.com
