Monitor Message Help

["Chuck Lewis" <chuck.lewis@xxxxxxxxxxxxxxxxx>]

OK folks - I give up. I've used Monitor Message for years for handling
printers mainly and found it pretty easy to setup new entries.

 

We I have one that is driving me crazy and I must be in "mondo dense
mode" apparently.

 

We have a web commerce app from a vendor and on the iSeries side it gets
an error every once in a while that needs to be replied to with a C
(cancel).  That is actually what they said to do...

 

Here is the error message that shows up on QSYSOPR:

 

 

                                Display Messages


                                                       System:   LEE


 Queue . . . . . :   QSYSOPR                 Program . . . . :   *DSPMSG


   Library . . . :     QSYS                    Library . . . :


 Severity  . . . :   95                      Delivery  . . . :   *HOLD


 


 Type reply (if required), press Enter.


   Error message CPF4131 appeared during OPEN for file OELMUSR1 (C S D
F).      

     Reply . . :   C


 
Bottom 

 F3=Exit              F11=Remove a message                 F12=Cancel


 F13=Remove all       F16=Remove all except unanswered     F24=More keys


                       

                                                         

And here is the detail:


 

 

                         Additional Message Information


 


 Message ID . . . . . . :   RNQ1216       Severity . . . . . . . :   99


 Message type . . . . . :   Inquiry


 Date sent  . . . . . . :   04/15/09      Time sent  . . . . . . :
07:55:47   

 


 Message . . . . :   Error message CPF4131 appeared during OPEN for file


   OELMUSR1 (C S D F).


 Cause . . . . . :   RPG procedure WBR2215 in program HD1100PO/WBR2215
received 

   the message CPF4131 while performing an implicit OPEN operation on
file      

   OELMUSR1. The actual file is OELMUSR1.


 Recovery  . . . :   Check the job log for a complete description of
message    

   CPF4131, and contact the person responsible for program maintenance.
If the  

   file has a device type of SPECIAL, there may be no message in the job
log.   

 Possible choices for replying to message . . . . . . . . . . . . . . .
:       

   D -- Obtain RPG formatted printout of system storage.


   S -- Obtain printout of system storage.


 
More... 

 Reply  . . . :   C


 Press Enter to continue.


 


 F3=Exit   F6=Print   F9=Display message details   F12=Cancel


 F21=Select assistance level


 


 Print operation complete to the default printer device file.


 

I've tried with the CPF and the RNQ, thought I had the position correct,
etc. and it still will not answer it. I think I've been messing with it
to the point where, as noted, I'm not seeing the obvious.

 

HELP :-)

 

Thanks folks !

 

Chuck