RE: SCO

["Neill Harper" <neill.harper@xxxxxxxx>]

I'd be willing to try and help you out but I'd need to see some code.

Neill

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of sjl
Sent: 17 May 2009 19:14
To: midrange-l@xxxxxxxxxxxx
Subject: Re: SCO

Batman (I mean Adam) -

No offense intended, but this is not an IBM Midrange-specific question.
I believe that you are more likely to get a response if you post your 
question in a .NET forum.

- sjl


Adam West wrote:
  This all works but for a small problem -
  when I run the report I first get prompted for the "SCO" parameter
  before it loads the main parameter lists.
  Then I get prompted again for the Company parameter
  to filter in the record selection.
  Is there any way that I can use the value of the parameter
  obtained at sql command level?
  Hope i've made sense.