The IBM 6400 printer we are trying to setup is connected to the LAN thru a
Micronet SP760 print server (parallel connection) on LPT1.
I tried changing the port 9100 but we get an error on the IP address/port.
I also tried the suggestions below and I got the following errors.
5722SS1 V5R4M0 060210 Job Log
S65509EB 08/10/09 14:35:15 Page 1
Job name . . . . . . . . . . : WTR_6400 User . . . . . . :
QSPLJOB Number . . . . . . . . . . . : 016465
Job description . . . . . . : QSPLPRTW Library . . . . . :
QGPL
MSGID TYPE SEV DATE TIME FROM PGM
LIBRARY INST TO PGM LIBRARY INST
CPF1124 Information 00 08/10/09 14:35:15.044056 QWTPIIPP
QSYS 066E *EXT *N
Message . . . . : Job
016465/QSPLJOB/WTR_6400 started on 08/10/09 at
14:35:14 in subsystem QSPL in QSYS.
Job entered system on 08/10/09 at
14:35:14.
*NONE Request 08/10/09 14:35:15.044528 QWTSCSBJ
*N QCMD QSYS 0194
From user . . . . . . . . . : D813
Message . . . . : -CALL QSYS/QSPWTRM1
CPD401A Diagnostic 40 08/10/09 14:35:15.331888 QWPSNMPD
QSYS *STMT QWPSNMPD QSYS *STMT
From module . . . . . . . . : WPSNMPD
From procedure . . . . . . :
Initialize_Driver
Statement . . . . . . . . . : 131
To module . . . . . . . . . : WPSNMPD
To procedure . . . . . . . : _C_pep
Statement . . . . . . . . . : *N
Message . . . . : Could not establish
SNMP communications with device
WTR_6400.
Cause . . . . . : Was not able to
establish SNMP communications with device
WTR_6400. The reason code is 2. The
reason codes and their meanings are as
follows: 1 - The device appears to be
an SNMP device but not a printer. 2 -
The device appears to be an SNMP
device but does not support the required
level of an industry standard SNMP
protocol. 3 - Communication with the
device timed out. This could occur
because of heavy network traffic, the
device is not an SNMP device, or the
read community name set on the device
is different than expected. Recovery
. . . : Make sure that the device is
a printer that supports the industry
standard SNMP protocol and that the
read community name is set correctly.
Then try the operation again.
CPF3473 Escape 60 08/10/09 14:35:15.332368 QSPOPNWX
QSYS 0246 QCMD QSYS 01C7
Message . . . . : Writer
016465/QSPLJOB/WTR_6400 did not end normally.
Recovery . . . : See the previously
listed messages to determine cause of
the writer failure. Correct any
errors and start the writer again.
CPC2402 Completion 50 08/10/09 14:35:15.339064 QCMD
QSYS 0668 *EXT *N
Message . . . . : Job ended. Cancel
message received at command processor.
Cause . . . . . : A message with a
severity equal to or exceeding the end
severity was received at the command
processor. Recovery . . . : See the
Panayiotis (Pete) Petrou
zVSE and Websphere MQ System Administration
Information Technology Division
Bank Of Cyprus
Tel 357-22-12-8473
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of
smorrison@xxxxxxxxxxxxxxxxxxx
Sent: Wednesday, October 07, 2009 9:54 PM
To: Midrange Systems Technical Discussion
Subject: Re: Problem with Printer Definition setup by a newbie to i5
Jack mentioned changing the port to 9100. Our 6400 is set to Workstation
Customization Object = *NONE, and System Drive Program = *IBMSNMPDRV. I'm
not sure what you'll get trying to use HPPJLDRV.
Steve
- -
Steven Morrison
Fidelity Express
"Panayiotis
Petrou"
<panayiotis.petro To
u@xxxxxxxxxxxxxxx <midrange-l@xxxxxxxxxxxx>
s.com> cc
Sent by:
midrange-l-bounce Subject
s@xxxxxxxxxxxx Problem with Printer Definition
setup by a newbie to i5
10/07/2009 10:42
AM
Please respond to
Midrange Systems
Technical
Discussion
<midrange-l@midra
nge.com>
We have an IBM 6400 line printer attached to a print server that we
currently use to print from our VSE system via TCP/IP LPR.
I have attempted to try and define a Printer device description on an i5
(see device description below) but I am not able to print.
Any help will be greatly appreciated.
The messages I am getting are as follows:
5722SS1 V5R4M0 060210 Job Log
S65509EB 07/10/09 12:38:21 Page 1
Job name . . . . . . . . . . : WTR_6400 User . . . . . . :
QSPLJOB Number . . . . . . . . . . . : 016337
Job description . . . . . . : QSPLPRTW Library . . . . . :
QGPL
SGID TYPE SEV DATE TIME FROM PGM
LIBRARY INST TO PGM LIBRARY INST
PF1124 Information 00 07/10/09 12:38:06.183544 QWTPIIPP
QSYS 066E *EXT *N
Message . . . . : Job
016337/QSPLJOB/WTR_6400 started on 07/10/09 at
12:38:06 in subsystem QSPL in QSYS.
Job entered system on 07/10/09 at
12:38:06.
NONE Request 07/10/09 12:38:06.184096 QWTSCSBJ
*N QCMD QSYS 0194
From user . . . . . . . . . : D813
Message . . . . : -CALL QSYS/QSPWTRM1
PD338D Diagnostic 40 07/10/09 12:38:21.214888 QWPPJLDR
QSYS *STMT QWPPJLDR QSYS *STMT
From module . . . . . . . . : WPPJLDR
From procedure . . . . . . :
Socket_Recv
Statement . . . . . . . . . : 40
To module . . . . . . . . . : WPPJLDR
To procedure . . . . . . . : _C_pep
Statement . . . . . . . . . : *N
Message . . . . : An error occurred
while receiving data.
More...
Cause . . . . . : A communications
error occurred while receiving data from
remote device at RMTLOCNAME
10.1.103.186. The error code is 3426. This error
can also occur when the system
attempts to print to the remote device after
it has been powered off and on
while
the printer writer remains active.
Recovery . . . : Try the request
again. If the problem continues, end
TCP/IP using the End TCP/IP
(ENDTCP)
command, start TCP/IP by using the
Start TCP/IP (STRTCP) command, and
then try the request again.
CPF3473 Escape 60 07/10/09 12:38:21.216408
QSPOPNWX
QSYS 0246 QCMD QSYS 01C7
Message . . . . : Writer
016337/QSPLJOB/WTR_6400 did not end normally.
Recovery . . . : See the
previously
listed messages to determine cause of
the writer failure. Correct any
errors and start the writer again.
CPC2402 Completion 50 07/10/09 12:38:21.235840 QCMD
QSYS 0668 *EXT *N
Message . . . . : Job ended. Cancel
message received at command processor.
Cause . . . . . : A message with a
severity equal to or exceeding the end
severity was received at the
command
processor. Recovery . . . : See the
messages previously listed to
determine the message that caused the job to
be ended. Correct the errors, and
then try the request again.
CPC2191 Completion 00 07/10/09 12:38:21.238544
QLIDLOBJ
QSYS 051B QLICLLIB QSYS 05DC
Message . . . . : Object SPLAPISPJL
in QTEMP type *USRSPC deleted.
Device description . . . . . . . . : WTR_6400
Option . . . . . . . . . . . . . . : *BASIC
Category of device . . . . . . . . : *PRT
Device class . . . . . . . . . . . : *LAN
Device type . . . . . . . . . . . : 3812
Device model . . . . . . . . . . . : 1
LAN attachment . . . . . . . . . . : *IP
Port number . . . . . . . . . . . : 515
Physical attachment . . . . . . . : *DIRECT
Online at IPL . . . . . . . . . . : *NO
Font:
Identifier . . . . . . . . . . . : 11
Point size . . . . . . . . . . . : *NONE
Form feed . . . . . . . . . . . . : *AUTOCUT
Separator drawer . . . . . . . . . : *FILE
Separator program . . . . . . . . : *NONE
Printer error message . . . . . . : *INFO
Message queue . . . . . . . . . . : *CTLD
Current message queue . . . . . . : QSYSOPR
Library . . . . . . . . . . . . : QSYS
Activation timer . . . . . . . . . : 170
Inactivity timer . . . . . . . . . : *SEC15
Line speed . . . . . . . . . . . . : 19200
Word length . . . . . . . . . . . : 8
Type of parity . . . . . . . . . . : *NONE
Stop bits . . . . . . . . . . . . : 1
Host print transform . . . . . . . : *YES
Manufacturer type and model . . . : *IBM6400
Paper source 1 . . . . . . . . . . : *CONT132
Paper source 2 . . . . . . . . . . : *NONE
Envelope source . . . . . . . . . : *NONE
ASCII code page 899 support . . . : *YES
Image configuration . . . . . . . : *NONE
Character identifier . . . . . . . : *SYSVAL
Remote location:
Name or address . . . . . . . . : 10.1.103.186
Workstation customizing object . . : QWPIBM64XX
Library . . . . . . . . . . . . : *LIBL
User-defined object . . . . . . . : *NONE
Object type . . . . . . . . . . : *NONE
Data transform program . . . . . . : *NONE
System driver program . . . . . . : *HPPJLDRV
Allocated to:
Job name . . . . . . . . . . . . . : *NONE
User . . . . . . . . . . . . . . :
Number . . . . . . . . . . . . . :
Published . . . . . . . . . . . . : *NO
Publishing information:
Support duplex . . . . . . . . . : *UNKNOWN
Support color . . . . . . . . . : *UNKNOWN
Pages per minute black . . . . . : *UNKNOWN
Pages per minute color . . . . . : *UNKNOWN
Location . . . . . . . . . . . . : *BLANK
Data streams supported . . . . . : *UNKNOWN
Text . . . . . . . . . . . . . . . : IBM6400 On 3rd floor Platy
Panayiotis (Pete) Petrou
zVSE and Websphere MQ System Administration
Information Technology Division
Bank Of Cyprus
Tel 357-22-12-8473
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/midrange-l.
Confidentiality Statement: This electronic mail transmission is
confidential, may be privileged and should be read or retained only by the
intended recipient. If you have received this transmission in error, please
notify the sender immediately and delete it from your system.
midrange.com
