There are 2 things you could do:
First, as was suggested by someone else, change the start up program to *NONE before doing the option 21 and reset it before doing the IPL.
Second, instead of doing 3 full saves, do just one and the dulicate the tape (DUPTAP command).
Denis Robitaille
Directeur Service technique TI
CASCADES INC.
412 Marie Victorin
Kingsey falls(QuÃbec) Canada J0A 1B0
T : 819 363-6130
F : 819 363-6155
Noah Sandestin <nsandestin@xxxxxxxxx> 2009-10-29 09:02 >>>
HI All,
On a monthly basis we run a full system (option 21) save and IPL our system. To do this, we have an operator who manually brings the system into a restricted state, goes to the save menu and executes option 21. As part of the option 21, when the save completes, it starts the controlling subsystem which then executes the qstruppgm. As I mentioned earlier, we IPL the system after the save finishes but our operator is having to wait for the system to start, then end back to a restricted state before he can IPL the system. It's been awhile since I have been through the option 21 save options, and I've done some reading online, but there doesn't appear to be an option to bypass the startup. Can anyone suggest a way around this?
Also, we are preparing for our DR test this December and want to execute 3 consecutive option 21 saves (2 to send to out DR partner, 1 to keep). As you can image, if the system starts after each one it would add a lot of time to this procedure. Any suggestions would be appreciated!
Thanks,
David Charmatz
midrange.com
