Re: STROBJCVN - Need to interrupt a V6R1M0 conversion

[PaultinNZ <paultormey@xxxxxxxxx>]

Okay panic over!

The conversion finished at 14:02 ... life goes on.

That's all for now.

On 18 April 2010 12:03, Paul Tormey <paultormey@xxxxxxxxx> wrote:

>  In my wisdom, I started the V6R1M0 STROBJCVN (*CONVERT) from my HMC Remote
> 5250 Console. Thoughts of having the system standalone while the conversion
> runs!
>
> This was run just after I had done the upgrade from V5R4M0 using PWRDWNSYS
> using an image catalog. Off course that all completed okay. But I suspect,
> didn't check, that the system is still in restricted mode?
>
> The pre upgrade ANZOBJCVN had been run and said the conversion would run
> for +/- 27 hours. The conversion started at 16:28 Sat 17/04/2010 and it's
> now 12:00 Sun 18/04/2010.
>
> Further reading on the list and redbooks shows that one need not run in a
> 'stand alone' environment.
>
> If I interrupt my HMC session and that ends the running STROBJCVN what are
> the implications?
>
>    1. Can I restart the conversion or would all that has been done be
>    backed out/rolled back?
>    2. I would IPL first so that the system is restarted in 'normal' mode.
>
> Any ideas or recommendations would be appreciated.