Re: QDSCJOBITV System Value

[CRPence <CRPbottle@xxxxxxxxx>]

rob@xxxxxxxxx wrote:
> I started a 5250 session. Got into WRKQRY. Clicked on the X to 
> abort the session without logging off or anything. I immediately
> got these in DSPLOG
> Job 838158/ROB/ROBCODE started on 05/19/10 at 09:39:54 in
>   subsystem QINTER  in
> Session to device ROBCODE ended normally.  
> Session stopped by a request from device ROBCODE.  
> Job 838158/ROB/ROBCODE ended on 05/19/10 at 09:40:02; .035
>   seconds used; end
>
> 7.1 of i and 7.1 of System i Access for Windows.
> System value QDSCJOBITV is set to 240.
> System value QINACTITV is set to *NONE
> System value QINACTMSGQ is set to *ENDJOB
>
> Started the session again and got right back to sign on screen.
>
> Perhaps there are some other system values at play here?

  A device error caused by canceling the terminal emulator session 
is dependent most directly on the DEVRCYACN() setting for the job, 
which may come from QDEVRCYACN system value; i.e. for having job 
attribute DEVRCYACN(*SYSVAL).  The timer that is the disconnect job 
interval would be germane only for the /disconnect/ options defined 
for device recovery; i.e. if device recovery action were set to 
*ENDJOB, what the value is for the disconnect job interval timer 
would be moot.?

Regards, Chuck