Re: Setting up IPDS printer

[Nick_Radich@xxxxxxxxxxxxxx]

Hi Aaron,

Try STRRMTWTR.






Nick



Nick Radich
Sr. Programmer/Analyst
EPC Molding, Inc.
Direct  (320) 679-6683
Toll free  (800) 388-2155  ext. 6683
Fax  (320) 679-4516
nick_radich@xxxxxxxxxxxxxx



From:   Aaron Bartell <aaronbartell@xxxxxxxxx>
To:     Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Date:   07/21/2010 04:19 PM
Subject:        Re: Setting up IPDS printer
Sent by:        midrange-l-bounces@xxxxxxxxxxxx



Lukas,

That command runs successfully.   I changed the name to ZEBRA11 and the IP
to 192.168.0.102.  I do a 2 on my ZPL spool file and specify an OUTQ of
ZEBRA11.  It goes to the ZEBRA11 OUTQ but it just sits there in RDY 
status.
 The OUTQ is in RLS status.  Do I need a writer attached to this OUTQ?

Aaron Bartell
http://mowyourlawn.com
http://mowyourlawn.com/blog/


On Wed, Jul 21, 2010 at 2:49 PM, Lukas Beeler 
<lukas.beeler@xxxxxxxxxxxxxxxx
> wrote:

> On Wed, Jul 21, 2010 at 21:15, Aaron Bartell <aaronbartell@xxxxxxxxx>
> wrote:
> > The Zebra GK420t arrived today.  I am pulling my hair out again
> concerning
> > the setup because I am too ignorant to try anything logical and am 
just
> > throwing mud at the wall at this point.  Too many terms being thrown
> around
> > on the web search results like "you don't need a WCST object" and 
"make
> sure
> > to configure it with a RMTPRTQ of 'PORTLF1' ", and I don't have a 
solid
> > understanding how a remote outq is different from a regular outq other
> than
> > I see it seems to be using some PASE type features when it is created
> (i.e.
> > '/prt01') via iNav.
>
> A Remotq Outq uses the LPR protocol to send a spool file to another
> system. The RMTPRTQ parameter specifies to which remote print queue
> it's being sent - in case of a directly network attached printer, this
> can be either inconsequential (Zebra print servers), specify the type
> of content (HP, for example) or in case of another system it can
> specify the other print queue (for example, when sending to another
> IBM i machine.
>
> Here's how i create my Zebra Remote OUTQ, with which i've installed a
> few GK420ts just a few weeks ago:
>
> CRTOUTQ OUTQ(PRTETIK) RMTSYS(*INTNETADR) RMTPRTQ('1') CNNTYPE(*IP)
> DESTTYPE(*OTHER) TRANSFORM(*YES) MFRTYPMDL(*WSCST) WSCST(QWPDEFAULT)
> INTNETADR('192.168.1.100') SEPPAGE(*NO)
>
> As you can see, RMTPRTQ is '1' in this case - this is a dummy value.
>
> Make sure you print SCS spool files that are 100% aligned to the left,
> no spaces, no nothing. This can cause issues, otherwise.