Re: BRMS Set Up

[Jim Oberholtzer <midrangel@xxxxxxxxxx>]

 Darell,

Yes, you will have to enroll the tapes.  If you also have the networking 
feature of BRMS, a really good thing to have and it's inexpensive, you 
can share tapes between the partitions without fear that one will 
overwrite another partitions tapes.  The network feature pays for itself 
in the reduced number of tapes you need to keep.

It sounds like you have most of the steps done, but a few questions for you.

  1. Did you set up the media classes so the expiration dates would
     work properly for you?
  2. Did you review the System policy, and back up policy to be sure
     the settings in there are correct for your installation?
  3. If there are any servers (domino, WAS, MQ, etc) you will have to
     watch the back ups to exclude several of the logs, flight
     recorders, etc that cannot be backed up while active.
  4. I would suggest you omit the libraries QMPGDATA and QPFRDATA. 
     They are not needed for a recovery and if collection services is
     running they will cause an error.
  5. Is the tape library in the correct mode (assuming there is a tape
     library)
  6. If you are sharing the tape device between the partitions have you
     set up the moves with the HMC?

Above all make sure BRMS maintenance is running every day after the back 
ups run and the recovery reports are moved to a place where you can get 
to them even if ALL of your systems are down.  Many of my clients have 
them emailed to their home account, or to me at the office.  In any 
case, if the recovery reports are only on the system you are trying to 
recover you'll have some intrigue on your hands.

As you can see there are a few details, this is not an exhaustive list 
by any means, of things to check but the good news is they are all easy 
and quick to do.

Jim Oberholtzer
CEO/Chief Technical Architect
Agile Technology Architects, LLC


On 8/31/2010 4:34 AM, Darell Wheeler wrote:
> Hi,
>   
> We have BRMS set up on the AS400 Partions.While the backup routines and scheduler entries are set up on the production partition and backups run on daily/weekly/monthly basis,I have to set it up on the development partition to get he backup going on the development partition.
>   
> I have copied the daily back up control group from the production partition and set it up on the development partition.I have also copied the daily backup scheduler entry from the prod partition and set it up on the dev partitions.
>   
> Can anyone please let me know the following:
>   
> 1.What else I have to do on the development partition to get the backup going successfully.
>   
> 2.The new tapes have been ordered for the dev partion and will be there next week.Do I have to enroll these tapes also in the BRMS.What steps and commands are involved here.
>   
> Please advice
>   
> Many Thanks