Re: Forms printing -- MIDRANGE-L

Fortunately, this is not a high volume form. Maybe a few hundred a day, but spread out over maybe 60 printers, none are IPDS.

Bad news is I finally got an opportunity to examine the form. Around 120 fields, many boxes with labels. Spacing, both vertical and horizontal, seems to vary. Looked like 5 lines/inch at one point and something between 8 and 12 cpi. I had hoped to use an overlay of the original Lexmark form for both sides. Back side is still likely, as it has two fields and no boxes - just lots of canned text.

I'm not clear on the initial steps of overlay generation. The Redbook says to load the AFP printer driver from Client Access. When I try, I get a message stating it is already loaded, but I don't see the same drivers as listed in the Redbook. That might be because there was a glitch and I installed from the web the Infoprint driver. The CA install share was mysteriously unavailable. Maybe I need to uninstall the Infoprint driver and try installing from the CA share again. We are on v5r4, and stalled, pending removal of the system in a few years (master planning of a corporate office - trash everything).

So, I san the original document into a JPEG file, then print it using any Windows application to a file using AFP driver. Upload file to IBM i, CRTOVL. Is this correct?

John McKee
-----Original message-----
From: Charles Wilt charles.wilt@xxxxxxxxx
Date: Wed, 02 Mar 2011 09:40:46 -0600
To: Midrange Systems Technical Discussion midrange-l@xxxxxxxxxxxx
Subject: Re: Forms printing

Note that there are some benefits to using an AFP capable IPDS printer...

With HPT, the overlay (and fonts) are sent as part of the spool data
stream for each spool file.

With IPDS, the overlay (and fonts) are sent as needed and can be
cached on the printer.

Also, my impression is the IPDS data stream is overall a bit more
reliable and easier to configure than HPT.

My preference and IBM's recommendation, is for IPDS printers for
critical and/or high volume printing such as invoices.

Charles

On Wed, Mar 2, 2011 at 7:22 AM, Michael Ryan <michaelrtr@xxxxxxxxx> wrote:

I usually use the AFP 300 printer driver.

I generate the forms using an overlay, and HPT to a laser printer.
Need to specify *AFPDS for the printer file, but just a regular laser
printer.

On Tue, Mar 1, 2011 at 10:44 PM, jmmckee <jmmckee@xxxxxxxxxxxxxx> wrote:

The redbook, http://www.redbooks.ibm.com/redbooks/pdfs/sg242160.pdf is easy enough to read. But, I have a couple of questions:

1) I have an existing blank form. I am assuming that the form would need to be scanned and then printed to a file using the AFP printer. Which one would I use?

2) Is an IPDS printer required, or would an AFPDS printer file work when directed to a laser printer. The form has boxes and text with different fonts.

Currently, forms are being generated by a forms chip inside a Lexmark printer. Would really be nice to not be tied to a specific printer model, which is no longer manufactured.

John McKee

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.