Re: Virtual tape transfer

[DrFranken <midrange@xxxxxxxxxxxx>]

Are you certain the file FTP'd correctly?  A couple checks would be if 
the size is exactly the same size on both side or to FTP it back to the 
original system and see if it works there after being copied over and 
back.  A tool that checksummed the file would be good, there is likely 
one for PASE.

    - Larry

On 2/16/2012 11:04 AM, rob@xxxxxxxxx wrote:
> Ok, I deleted my target virtual catalog and QIMGCLG file.  I ftp'd over a
> new QIMGCLG.  Then I ran
> CRTIMGCLG IMGCLG(VRTCLG)
>            DIR('/vrtclg')
>            TYPE(*TAP)
>            CRTDIR(*NO)
>            IMPORT(*YES)
> WRKIMGCLGE now shows:
>   Index  Status      Volume Name  Density     Type  Write Protect
> *AVAIL
>       1  Mounted       VRT001     *VRT256K    *SL    No
>       2  Loaded        VRT002     *VRT256K    *SL    No
>
> 8=Load
> Image catalog VRTCLG not loaded to device VRTDEV.  CPFBC10
>
> Message . . . . :   Image file not valid for tape type image catalogs.
> CPD4F1D
>
> Cause . . . . . :   The image file associated with image catalog entry 2
> is
>    not valid for tape type image catalogs.
> Recovery  . . . :   Use the Remove Image Catalog Entry (RMVIMGCLGE)
> command to
>    remove image catalog entry 2, and then try the request again.
>
> It really doesn't like that second image.
>
> Also tried Kirk's method:
> RSTOBJ OBJ(VRTCLG) SAVLIB(QUSRSYS) DEV(*SAVF) OBJTYPE(*IMGCLG)
> SAVF(ROB/ROB)
> 8=Load
> CPD4F1D - Image file not valid for tape type image catalogs.  ...entry
> 2...
>
>
> Rob Berendt