Rob wrote:
Again, any takers as to how I get WRKHDWRSC *STG to show this as a
tape library?
Not familiar with 3583 but some suggestions :
Have you checked that it is supposed to work on interoperation center
(although, sometimes, some "old" configuration may work when specified
not working) ?
http://www-03.ibm.com/systems/support/storage/ssic/interoperability.wss
Is there a drive in the logical library (or for the entire library if
none has been configured) which owns the control path ?
Did you setup the port type to L-port as stated in "Setup, Operator,
and Service Guide", chapter 4/Installation and
Configuration/Configuring Your Library/Choosing Drive(s) Interface
Identification/Settings ?
I can read "Note: If you have a Fiber Channel Drive connected to an
AS/400 Host, direct attached to the Fiber HBA, set the Port Type to L-
Port.".
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
